User manual

3. Position Change („SLOPE“)

The same sensor as for „SHOCK“ is able to determine the direction of gravity and thus deﬁne the current

position of the GX111. If the GX111 changes its position (angle, not location!), this may be used to trigger

an alarm.

It is not important which axis the product turns around, but that each axis is looked at separately.

Thus, a diagonal can lead to a higher total angle than permitted. This must be observed when

determining the threshold.

The axes run along the housing edges.

The following command sets the threshold of a position change to <slope threshold>. At the time, the cur-

rent position in space is saved as a reference value. If the position deviates from the set reference value

by the set threshold, an alarm is triggered.

SET SLOPE <slope threshold> #1513

Threshold:1-180(1=minimumslopeindegrees,180=maximumslopeindegrees)

Note:

As a threshold, the angle change to the position is set in which the product was at the time of

„SET SLOPE…“.

The currently measured value for „STATUS“ is also based on this reference position.

 Thereisnodierentiationbetweentheindividualaxes;themeasuredvalueoftheaxiswiththe

highest deviation is assessed and displayed at all times.

Diagonal angles are not considered.

 A„diagonal“zeropositionoftheGX111canreducetheaccuracyoftheanglecalculation.The

GX111 therefore should always be in parallel with the surface of the earth on the one side.