User manual

Programming Quick Guide - LS6300E
Installation
Make sure that the scanner has the correct cable to plug in
the PC as below described::
USB cable Connection: / PS2 cable connection
(Please use correct cable for the interface)
Reset Configuration to Defaults
If you are unsure of the scanner configuration or have
scanned the incorrect codes, please scan the “Set
Factory default” barcode. This will reset the scanner to
its factory defaults.
Default
Indicator Information
Red LED ON Not read
Green LED Good read
OUTPUT MODE –
KEYBOARD / USB
OUTPUT
MODE
SINGLE SCAN
SINGLE SCAN NO
TRIGGER
READING
MODE
LASER TIMEOUT
–5 SECONDS
LASER TIMEOUT
–2 SECONDS
CODE 11 DOUBLE
CHECK - ENABLE
CODE 11 DOUBLE
CHECK - DISABLE
DOUBLE
CHECK
CODE 39 DOUBLE
CHECK ENABLE
CODE 39 DOUBLE
CHECK DISABLE
CODE 93 DOUBLE
CHECK - ENABLE
CODE 93 DOUBLE
CHECK - DISABLE
CODE 128 DOUBLE
CHECK - ENABLE
CODE 128 DOUBLE
CHECK - DISABLE
I2OF5 DOUBLE
CHECK - ENABLE
I2OF5 DOUBLE
CHECK - DISABLE
DOUBLE
CHECK
ID2OF5 DOUBLE
CHECK - ENABLE
ID2OF5 DOUBLE
CHECK - DISABLE
MSI DOUBLE
CHECK - ENABLE
MSI DOUBLE
CHECK - DISABLE
UPC/EAN DOUBLE
CHECK ENABLE
UPC/EAN DOUBLE
CHECK DISABLE
REVERSE IMAGE
– ENABLE
IMAGE
REVERSE IMANGE
- DISABLE
SEND BAR CODE
ID - DISABLE
CODE ID
SEND BAR CODE
ID – AS A PREFIX
SEND BAR CODE
ID - RESET
SEND BAR CODE
ID – AS A SUFFIX