User manual

Pairing

The headphones and charging/transmission station are supplied paired. Following a loss of connection of under other

circumstances, pairing may be lost. In that case, a wireless connection cannot be established and the pairing process

must be repeated.

• Ifnowirelessconnectioncanbeestablishedbetweentheheadphonesandcharging/transmissionstation,thePAIR

indicator (10) lights up.

• In that case, press the SCAN button (1) on the charging/transmission station and the CH button (18) on the head-

phones for three seconds simultaneously.

• TheAUX/MICINindicator(8)onthecharging/transmissionstationandPAIRindicator(10)ontheheadphonesash

during the pairing process.

• Once the connection has been established, both indicators light up continuously.

Carry out pairing only if you cannot establish a wireless connection.

Function of indicators and controls on the headphones and charging/transmission station

Indicators and controls Function

SCAN button (1) Press for 3 seconds to start pairing

ON/OFF switch (5) Switches the charging/transmission station on or off

POWER/CHARGEindicator(7) Green >> Charging/transmission station is switched on

Yellow >> Battery in headphones is being charged.

AUX/MIC IN indicator (8) Green >> Audio signal available at AUDIO IN (3) or MIC IN (2)

Flashing green >> Pairing

Yellow >> No audio signal available

STANDBY indicator (9) Continuous red >> Headphones in standby mode

Flashing red >> Wireless signal lost (e.g. range exceeded)

PAIRindicator(10) Blue >> Wireless signal was detected

Flashing blue >> Pairing

Does not light up >> No wireless signal detected

VOL control (11) Controls the volume of the headphones

ON/OFF switch (12) Switches the headphones on or off

TONE control (13) Controls the tone of the headphones

BALANCE control (14) Adjusts the volume of the right-hand and left-hand side of the headphones

CH button (18) Press for 3 seconds to start pairing

The charging/transmission station switches the wireless connection off automatically after a short time if no

audio signal is available. If a new audio signal is detected, the charging/transmission station transmits it.

If no wireless signals is being received, the headphones switch to standby mode after a short time. The

headphones switch on automatically when a wireless signal is detected.