User manual

- 1 - 2-C107-01A
GigaLAN 1000BASE-T Ethernet PCIe x1 M.2 A-E Key Module
1. Introduction
Add PCIe x1 High-Speed 1000 /100 /10 Mbps BASE-T RJ-45 Ethernet
Gigabit LAN through your IPC M.2 E Key or A Key slot!
1.1. Features
o M.2 NGFF type 2260-xx-A-E 75Pin Dual A-E Key LAN module
o Support M.2 type 2230 and 2260 plated-holes
o Fully compliant with IEEE 802.3 (10Base-T Ethernet), IEEE 802.3u (100Base-TX
Fast Ethernet), IEEE 802.3z (1000Base-T Gigabit Ethernet)
o Compliant with PCI Express Specification, revision 1.0a
o PCI Express 1-Lane host interface
o RJ-45 Port offer high speed transmission over CAT 5 UTP cable
o 2 LEDs indicate for various network activities (1000 and LNK/ACT)
o Auto-Negotiation with Next page capability
o Supports pair swap/polarity/skew correction
o Crossover Detection & Auto-Correction
o Microsoft® NDIS5 Checksum Offload (IP, TCP, UDP) and largesend offload support
o Supports Full Duplex flow control (IEEE 802.3x)
o Supports IEEE 802.1Q VLAN tagging
o Jumbo Frame sizes 9K bytes
o Configurable 48KB deep Buffer support
o Provides driver for 32/64 bit Windows 10, 8.1, 8, 2012, Win7, 2008, Vista, XP, 2003
and Mac OS X 10.4, 10.5, 10.6, 10.7
2. Installation
2.1. Hardware installation
1. Plug Gigabit LAN M.2 module into motherboard M.2 A Key or E Key socket
2. Connect the RJ-45 cable / plug.
3. Check the Link LED in M.2 module if the cable is connected correctly
2.2. Software Installation
1. During OS boot up, Windows will display the Found New Hardware Wizard, “Ethernet