User manual

8. Commissioning - First Steps

Thefollowingisneededforoperationandcongurationofthedevice:

• AconventionalmobilephonethatpermitsinsertionofamicroSIMcardforcongurationoftheGX111.

 Ifyourmobilephoneisnotequippedforusewithamicro-SIMcard,youwillneedthecorrespondingadap-

ter.

• AnadditionalmicroSIMcardfortheGX111

• AUSBport(PC,notebookorincludedmainsadapter)withUSBcable

• AsmallPhillipsscrewdriverforM2screwstoremovethecoversoftheGX111

a) Assembly and Charging of the Product

Theproductisdeliveredwiththerechargeablebatteryinserted.However,itisnotconnectedtopreventdeepdischar-

ge.

Therefore,thehousingoftheGX111mustbeopenedandthePCBremovedforrstcommissioning.Thentherechar-

geablebatterycanbeconnectedandtheGX111assembledagain.

Particularly observe the following items during assembly:

Rechargeable battery connection:

ThereisaconnectionfortherechargeablebatteryonthePCBsidewiththeSIMholderrightnexttoit.Theplugis

pushedontotheholderfromthetop.Theplugisprotectedagainstpolarityreversal.

Rear cover (without opening for light sensor)

ThecoverisrmlyscrewedtothehousingandcoversthelargeopeningwiththePCBandtherechargeablebattery.

Thecovermustberemovedtoreplacetherechargeablebattery.ThenthePCBwiththerechargeablebatterycanbe

pulled from the housing.

Whenputtingittogether,observethatthesealonthecoverinsideisplacedcleanlyandhasnodamage.

Therubberwashersalsomustbeusedforscrewingtoensurebestweatherresistance.

Front cover

ThiscovercoversallconnectionsandstatusLEDsandhasonlyatransparentopeningforthelightsensor.Onlythis

coverneedstobeunscrewedforregularaccesstotheproduct(USB,SIM,etc…).

Therequirementstoassemblyofthefrontcoverarethesameasfortheinternalcover.However,observethatthe

transparent opening should be checked for contamination so that the light sensor can work properly.