User manual

c) Connection of the Control Lines for the Remote Control

If you connect any other devices of the Renkforce HiFi series to the ampliﬁer, you can remote-control these

devices via the system remote control.

For this, the control sockets of the individual devices must be connected to the control sockets of the am-

pliﬁer. The control lines are enclosed with the individual devices.

• ConnectthecontrolsocketoftheequalizertothecontrolsocketREMOTESYSTEMEQattherearofthe

ampliﬁer.

• ConnectthecontrolsocketofthetaperecordertothecontrolsocketREMOTESYSTEMTAPEattherear

of the ampliﬁer.

• ConnectthecontrolsocketofthetunertothecontrolsocketREMOTESYSTEMTUNERattherearofthe

ampliﬁer.

• ConnectthecontrolsocketoftheCDplayertothecontrolsocketREMOTESYSTEMCDattherearofthe

ampliﬁer.

d) Mains Connection

Before plugging in the mains plug, ensure that the device voltage indicated at the device cor-

responds to the available mains voltage. Do not connect the device if the indication does not

correspond to the available mains voltage. Wrong supply voltage will cause serious damage.

Be careful when handling mains cables and mains connections. Mains voltage may cause po-

tentially fatal electric shock.

The mains socket to which the device is connected must be easily accessible so that it can be

separated from the mains voltage quickly in case of an error.

The ampliﬁer and all connected devices must be switched o when the power supply is con-

nected.

Make sure that no cables lie around openly. Install cables professionally to prevent accidents.

Make sure that all electrical connections and connection cables between the dierent devices

and any extension cables comply with the regulations and the operating instructions. If an ex-

tension line is used, ensure that it is designed for the respective load.

• Connectthemainsplugoftheampliertoasocket(230V/50Hz)ofthepublicmainssupply.