User manual

41
• NowusethesettingwheelortheIRremotecontroltochoosewhetherthesetupwizardistobestarted
or not and confirm your selection.
Observe the previous chapter 13 b) for your procedure for operation.
• Ifyoudidnotstartthesetupwizardinthepreviousstep,aquerywillappearinthedisplaytoaskyouif
you want to execute the setup wizard again at the next start (this may require the Internet radio to be
disconnectedfromthemainsvoltagebriey).
Proceed as follows after starting the setup wizard:
• Intherststep,youcanswitchthedisplayformatforthetimebetween12and24hmode.
For 12 h mode, „PM“ is displayed next to the time for the second half of the day (e.g. „2:18PM“ in
12 h mode = 14:18 in 24 h mode).
Confirm the setting as usual by pushing the setting wheel or the button „ “ (2) of the IR remote control.
• Thefollowingdisplaypermitsselectionofwhetherthedateandtimearetobesetautomaticallyornot.
In automatic setting, the Internet radio will search a time server to set the internal clock.
Confirm your selection.
If you do not desire automatic setting, manually enter the date and time afterwards.
You can set the date, month, year, the hours and minutes of the time in sequence with the setting
wheel. A brief push on the setting wheel will switch to the respective next value.
• IfyouhaveselectedandconrmedtheautomaticupdateofdateandtimethroughtheInternet,younow
need to set the proper time zone (not possible/required for manual setting of date/time).
Example: Use „UTC +01:00“ as the time zone for Germany.
Confirm the setting of the time zone by pushing the setting wheel or the button „ “ (2) of the IR remote
control.
• Thenautomaticswitchingofsummer/wintertimecanbeactivated/deactivated.
When activating this function, the time display switches to the respective right value for summer/winter
time.
• NowthemostimportantitemfortheInternetradiofollows:selectionoftheWLANnetwork.
 TheInternetradiowillautomaticallyscanforavailableWLANs;thismaytakeseveralseconds.Thenthe
display will show all the WLAN networks that were found during the search.
If no WLAN networks are displayed, observe the following notes:
Check if the WLAN aerial is properly screwed on to the back of the Internet radio.
Put the WLAN aerial into a dierent position. Do not point the tip of the aerial at your WLAN router
or WLAN access pint, since this will reduce range. Instead, the aerials should be in parallel to
each other.
If required, move the Internet radio. If the Internet radio is used, e.g. in a HiFi-rack made of metal,
good WLAN reception cannot be expected there.
Set up your WLAN router or WLAN access point elsewhere.
Check if the WLAN of your router or access point is switched on and whether the SSID is visible.
If you have specifically configured your network (e.g. fixed IP addresses, etc.), the setup wizard
cannot establish any WLAN connection. Instead, you have to manually configure the network
connection;seechapter14e).Thisrequiresknowledgeinhandlingofnetworks.