User manual

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in

electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.

This publication represent the technical status at the time of printing.

PC or MAC:

• You can also operate the converter board with a PC or MAC.

• In principle, installation and operation with a PC or MAC is the same as with the Raspberry Pi

Please note! The converter board is not designed for installation in a PC or MAC. If

you nevertheless plan to do so, please observe the special safety instructions of this

manual.

Since the screw set is only intended for attachment to a Raspberry Pi

, make espe-

cially sure that the converter does not cause a short circuit in this case (e.g., through

contact with the PC housing).

When using the 5-pin connector (USB_P or U20_P1), also observe the operating instructions

of your computer or main board for the correct allocation.

Disposal

Electronic devices are recyclable material and do not belong in the household waste.

Please dispose of the product, when it is no longer of use, according to the current

statutory requirements.

You thus full the legal requirements and make your contribution to protecting the

environment.

Technical Data

Voltage supply ................................... via micro USB2.0 (USB_M or U20_M1) or 5-pin con-

nector (USB_P or U20_P1); alternatively via micro USB

connector (PWR_U or DC5V_IN)

Operating voltage .............................. 5 V/DC

Supported operating systems ............ Windows

XP SP1 or higher (only 32 bit); Windows

Vista

, Windows

7, Windows

8, Windows

8.1,

Windows

10 (32 and 64 bit); MacOS; Linux

Connectors ........................................ M.2 NGFF 2280-D5-B port (B key); micro USB2.0

connector; 5-pin USB connector; micro USB connector

for separate voltage supply

Supported standards ......................... USB 2.0; SATA

Supported devices ............................. M.2 NGFF SATA SSD; type: 2280, 2260, 2242, 2230;

double sided module, max. height 1.5 mm

Dimensions (L x W x H) ..................... 89 x 57 x 12 mm

Weight ............................................... approx. 20 g (only the board)

Operating conditions .......................... 5 °C to +50 °C; 20% to 80% rF, non-condensing

Storage conditions ............................. -25 °C to +70 °C / 15% to 90% rF non-condensing