User manual

39
Connection of additional devices
• The device has a socket each (3.5 mm jack) for a headphones (16) and for an external device (18), such as an
MP3 player, at the rear.
• To connect a headset to the product, simply connect the plug to the headphone connection (16) of the internet radio.
The speaker is automatically switched off and the music is played only on the connected headphones.
• To connect an external device to the product, connect its output with a corresponding cable with the
AUX-in input (18) of the internet radio.
• Then,turnontheexternaldeviceaswellandstartplayback.Youmustswitchtheinternetradiotothe“AUX”mode.
• Connect the line-out connector (17) of the internet radio to a compatible playback device such as an external
speaker. The speaker of the internet radio is not switched off. The music is played on the connected device.
b) Inserting/replacing the remote control batteries
Youhavetoinsertthebatteriesbeforeyoucanusetheremotecontrol.Proceedasfollows:
• First remove the battery cover of the remote control. For this, slide down the lid on the back.
• Insert two AAA-batteries (not included with the device) in the battery compartment. Please observe correct polarity
(plus/+andminus/-).Thisishighlightedinthebatterycompartment.
• Now slide the cover up again into the remote control until it clicks into place. Inserting/replacing the batteries is
now complete.
Later, if you need to replace the batteries, proceed just as you do when you insert them, with the only
differencethatyouneedtorstremovetheoldbatteries.
9. Initial set-up
• “Renkforce”appearsonthedisplaywhenyouswitchtheradioonforthersttime,orwhenyouswitchitonafter
disconnecting it completely from the network. Wait for a few seconds while the radio turns on. The progress bar
indicates the loading status.
• If you wish to change the following settings later, they can be found in the "Settings" menu option. The individual
sub-menus are “Language” and “Network”.
• Alanguagemenuwillbedisplayedwhenyouturntheradioonforthersttime.
• Select your desired language with the help of the (H and 8) and (F and 10) buttons on the remote control.
• ConrmwiththeOK button (N and 3).
• A prompt will appear next, asking whether you want the radio to check the Wi-Fi connection each time you turn
the radio on.
• Select“Yes”or“No”withthebutton (G and 6) or (O and 5) .
• ConrmagainwiththeOK button (N and 3).
• YoucansetuptheWi-Ficonnectiononthenextscreen.Here,youhavethechoicebetween“No”,“Yes(WPS)”and
“Yes”.Usethe (G and 6) or (O and 5) button to select again and the OKbutton(Nand3)toconrm.
Select “No” if you want to set up the Wi-Fi connection later.