User manual

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights

includingtranslationreserved.Reproductionbyanymethod,e.g.photocopy,microlming,orthecaptureinelectronicdata

processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication

represent the technical status at the time of printing.

Placing Device into Stand

 Alwaysmakesurethetopplateissecurelyfastenedandthedeviceisrmlyheldin

place before letting go.

Wall or Ceiling Mounting

When drilling or tightening screws, make sure not to damage any cables, wires or

pipes located underneath the surface. Inadvertently drilling through electric cables

causes the life-threatening danger of an electric shock!

Wall-mounting is permissible only where the wall concerned is of the correct type

and condition. Lightweight partition walls or those made from gypsum boards are

normally unsuitable.

 Makesurethatthexinglocationissufcientlystableandrm,inordertosupport

the product and your device.

Check before working, whether the screws and dowels enclosed are suitable for the

relevant wall mounting. If in doubt, contact a specialist before installing the product.

The choice of an unsuitable installation location can lead to personal injury or

material damage!

 Preparethesurfaceforinstallation.Itshouldbedry,clean,atandfreefromdebris.

Use a 6 mm diameter drill bit to prepare holes for the dowels.

Do not over tighten screws as this may damage the base plate.

 Alwaysmakesurethetopplateissecurelyfastenedandthedeviceisrmlyheldin

place before letting go.

You can use the holes on the base plate as a template to mark where to place the

dowels.

Care and Cleaning

• Remove the device from the stand before each cleaning.

• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as

they can cause damage to the housing and malfunctioning.

• Cleantheproductwithadry,bre-freecloth.

Technical Data

Material ......................................... AS (acrylonitrile-styrene copolymer)

Operating/storage conditions ........ 0 to +40 °C, 10 – 90 % relative humidity

Dimensions (Ø x H) ...................... 110 x 40 mm

Weight .......................................... 81 g