User manual

2.5”/3.5” D ual SATA HDD Docking Station Installation Guide
12
STEP3: Press & hold the clone button for at least 4 seconds, and clone
operation will start having the RED Power LED disappear and all 4
LEDs turned on in orange.
STEP4: Following light-on of all 4 LEDs in orange, LEDs will then proceed to
running back & forth indicating the clone progress. Each orange LED
refers to every 25% of clone completion. It is only when every 25%
of HDD1 is cloned to HDD2 that such LED will remain constantly on,
leaving the other LED(s) in running stage. When Clone operation is
fully completed, all LEDs will flash regularly in orange color until the
device is power cycled.
NOTICE: Any time clone operation fails, LED on HDD2 flares in red, leaving
the other LEDs off. Refer to Section 4.4 & 4.5 in “Normal & Clone Mode
Table Chart” under “Diagnosis of LED” in below “NOTE” session for details.