User manual

2.5”/3.5” D ual SATA HDD Docking Station Installation Guide
13
Erase Operation Guide
STEP1: Follow Step 1 & 2 from Clone Operation Guide
NOTICE: Install at least 1 HDD/SSD to the docking station
STEP2: Pin & hold the erase button for at least 4 seconds. During this
period, power & HDD2 LED light up in red. Then, operation will
start swapping to all 4 LEDs in red.
STEP3: Following light-on of all 4 LEDs in red, LEDs will then proceed to
running back & forth indicating the Erase progress. Each red LED
refers to every 25% of Erase completion. It is only when every 25%
of all HDD(s) is erased that such LED will remain constantly on,
leaving the other LED(s) in running stage. When Erase operation is
fully completed, all LEDs will flash regularly in red color until the
device is power cycled.
NOTICE: Percentage of Erase completion attributes to erasing all sectors of the
inserted HDD(s). For example, total no. of sectors for two 3TB HDDs is double