User Manual

Flip inverter power to the “OFF’ position

Unscrew the screw terminals along the edge of the side plate

Gently remove DC Side plate to expose DC Terminals

Connect the positive and negative DC Cables to their respective terminals and run them

through the side panel

The Terminals must clean to reduce the resistance in the cable connection. A

buildup of dirt or oxidation may eventually lead to the cable terminal overheating

during periods of high current draw

DC WIRING

The Renogy Pure Sine Wave Inverters are suitable for 12V battery bank systems ONLY.

Not following the minimum DC requirement will cause irreversible damage to the unit.

WARNING

CAUTION

Be careful of the positive and negative poles. Reversing the poles might cause

permanent damage to the inverter. It will surely blow the internal fuse.

NOTE

Damage to the Renogy inverters due to reverse polarity is NOT covered by warranty.

NOTE

The input terminals of the inverters have large capacitors connected to them. Once

a positive and negative wire are connected to the terminals, it will complete the

circuit, and commence drawing a heavy current momentarily. As a result, there may

be a sparking occurring even if the inverter is in the off position. To minimize

sparking, it is recommended that the user have the appropriate size wire feeding into

the inverters and/or install an external fuse leading into the inverter.

Ensure all sources of DC power (i.e., batteries, solar, etc.) and AC power (utility

power or AC generator) are de-energized (i.e., breakers opened, fuses removed)

before proceeding—to prevent accidental shock.

To Access the main panel, unscrew the terminals on the outside of the side panel.