Owners manual

7
B. Slide spring washer through the threads of the 25mm Cap Bolt and then slide washer so
that both make contact with the 25mm Cap Bolt’s underside.
C. Flush L-Joint to the back of the panel as shown in the pictures.
D. Align 25mm Cap Bolt with spring washer and washer through the L-Joint base hole. Follow
up by adding a washer after the hole and then use a nut to tighten into place.
E. Repeat for all 4 L-Joints. Refer to the picture for correct orientation of the L-Joints. Note
that the back of the L-Joints face away from the panels longitudinal center.
Note: The back of the L-Joints face away from the panel’s longitudinal center.