Full Product Manual

Inverter Troubleshooting

Eco Power Saving Mode Instruction

This inverter features a power saving mode to conserve battery power. To enable this

function, set the DIP switch to ECO.Please note, the DIP Switch for the mode needs to be

set BEFORE turning on the inverter.

Under power saving mode the inverter senses the output power being drawn. It shuts down

the output power and remains on standby with lower idle consumption if the AC load is less

than 50 watts.

The inverter will send a pulse once every 3 seconds to look for AC load. You will also notice

the power light start to pulse, indicating ECO mode. If the inverter detects a load greater than

50 watts it will automatically start inverting, restores the output to power the load. When all

loads are turned off the inverter will go back into search mode.

Input voltage is below 11V

Input voltage is above 15V

Input voltage is below 10.5V

Input voltage is above 15.5V

GFCI tripped

Use a higher wattage inverter or

use a lower powered device

Disconnect the inverter and turn

off the ON/OFF switch to reset

Disconnect appliances and turn

off the ON/OFF switch to reset

Inverter overheats

Operating equipment draws too

much power

Yellow LED Lit -

Inverter shut down

Fault LED Lit, Inverter

Shut Down and alarm on

Fault LED Lit and

alarm beeps

Inverter is short circuited

Keep input voltage below 15V

Keep input voltage above 10.5V

Keep input voltage below 15.5V

Allow inverter to cool down

Check for adequate ventilation

Reduce the load on inverter

Keep input voltage above 11V

Indicator TroubleshootPotential Issue