Full Product Manual

Alarm

—If there is a buzzing sound, the battery is low. The user should reduce the

AC load, charge the battery, and check the DC cable for excessive losses.

LEFT

Neutral (N) Ground(G)

Middle Right

Live(L)

2. Power LED (Green)

— When this green LED is lit, the inverter is operating.

— When this green LED is flashing, the inverter is in ECO power

saving mode.

Facing the front panel, the terminals are:

NOTE

NEUTRAL and GROUND are bonded inside the inverter to comply with the National Electric

Code (NEC) requirement that any AC source must have aneutral to ground connection.

GFCI LED (Yellow)

— When the yellow LED is lit, the ground fault circuit has been interrupted.

Shut down the inverter and restart.

Fault LED (Red)

— The red indicator turns on as the inverter shuts down due to overheating,

overload,

under voltage, or over voltage.

Immediately turn off all AC appliances if the Fault LED is lit. Allow the inverter to cool

before continuing. Make sure that the ventilation vents are not blocked.

If an inverter shutdown was preceded by a buzzing sound, there may be an excessive

load in combination with low voltage or a cable problem.

ON/OFF Switch

— Controls AC Output and Remote feature

AC Outlets

— Up to 8.3 amps (1000W), Up to 15 amps (2000W) at 110V AC 60 Hz.

Communication Port

—RS485，data transmission

Remote Switch Connection

— Insert wired remote switch to the connection port. Set

ON/OFF switch to "remote" position.

50Hz/60Hz-

Switches between 50Hz and 60Hz

Eco/Nor-

Switches between Energy Saving mode and Normal mode