Quick Guide

1010
Installation
Input Wiring
The battery charger input terminal can be directly connected to the vehicle's starting battery or
DC generator. If you want to wire directly to the DC generator, please refer to the user manual of
REGO 12V 60A DC-DC Battery Charger at renogy.com for more detailed instructions.
z
Please check the vehicle's manual to identify the generator type before connecting. If you
cannot identify the generator type, please refer to the user manual of battery charger at
renogy.com for more detailed instructions.
z
The starting voltage of the battery charger input terminal depends on the generator type. If
it is a smart generator, the starting voltage should be greater than 12.5V; if it is a traditional
generator, the starting voltage should be greater than 13.5V.
z
Identify the polarity (positive and negative) on the cables used for the batteries. A reverse
polarity contact may damage the unit.
z
Select a suitable wrench or other tool when tightening the battery bolts to their rated
specification.
z
Please ensure that the ring terminals are securely connected.
Input -
STEP-4.1
-
-
input output
DC-DC Battery Charger
Attach the ring terminal of
the negative Battery Adapter
Cable (input) to the negative
bolt of the starting battery.
IGN
CAN CAN
BVS BTS
STEP-4.2
IGN
CAN CAN
BVS BTS
If the DC generator of the
vehicle is a smart generator,
insert the IGN Signal Wire
connector into IGN signal
wire port, and then connect
the other end to the smart
generator's ignition signal
port.