Installation Guide

SM
SOLAR
MOUNT
INSTALLATION GUIDE
PAGE
INSTALL MODULE ENDCLAMPS: The Endclamp is
supplied as an assembly with a T-bolt, serrated ange
nut, and washer. The washer retains the clamp at the
top of the assembly. This will enable the clamp to
remain upright for module installation.
ENDCLAMP & FIRST MODULE
T
INSTALL FIRST MODULE: Install the rst end module
onto rails. Engage module frame with Endclamps.
Verify that the position indicator & T-bolt shaft are
angled in the correct position.
TORQUE VALUE (See Note on PG. Q) 1/4” nuts to 10
ft-lbs. w/Anti Seize
POSITION INDICATOR - SERRATED T-BOLT: Verify the
T-bolt position indicator is perpendicular to the rail.
POSITION INDICATOR - NON-SERRATED T-BOLT:
Verify the T-bolt position indicator is angled as
shown. FOR USE WITH MILL FINISH RAIL ONLY.


INSERT ENDCLAMP T-BOLT: Insert 1/4” T-bolt into
rail.
ROTATE ENDCLAMP T-BOLT: Rotate T-bolt into
position. Verify that the position indicator & T-bolt
shaft are angled in the correct position.
End clamps are positioned on rails prior to the rst
end module and installed after the last end module.


1/2"
MIN.
 

