Installation Guide

SM
SOLAR
MOUNT
INSTALLATION GUIDE
PAGE
ROTATE MIDCLAMP T-BOLT: Rotate bolt into position
and slide until bolt and clamp are against module
frame. Do not tighten nut until next module is in
position. Verify that the position indicator & T-bolt
shaft are angled in the correct position.
 
INSERT MIDCLAMP T-BOLT: Apply Anti-Seize and
insert 1/4” T-bolt into rail.



INSTALL MIDCLAMPS: Midclamp is supplied as an
assembly with a T-bolt for module installation.
Clamp assemblies may be positioned in rail near
point of use prior to module placement.
BONDING MIDCLAMP & TRIM
U
POSITION INDICATOR - SERRATED T-BOLT: Verify the
T-bolt position indicator is perpendicular to the rail.
TRIM MIDCLAMPS: Ensure Trim lip is in contact with
module face and verify alignment marks on T-bolts
are in proper position, tighten midclamp on Trim,
repeat at each gap between modules.
TORQUE VALUE (See Note on PG. Q)
1/4” nuts to 10 ft-lbs w/ Anti Seize
TRIM INSTALLATION INSTRUCTIONS