Installation Guide

SM
SOLAR
MOUNT
INSTALLATION GUIDE
PAGE
PREPARATION: At front edge of array,
ensure at least 3.25 inches of space
between modules and roof surface
and that modules are aligned to within
3/8”. Plan for Trim length so that
Endclamps can be properly installed.
INSERT MIDCLAMPS: Insert T-bolt
into slot and slide clamp (rotating
Trim) into position between modules
and leave loose. Continue to work
down array, inserting Midclamps and
positioning in gaps between modules.
1ST MIDCLAMP: Position Trim in front
of array. Insert Midclamp into the Trim
slot, aligned with the gap between the
1st two modules at either end of array.
NOTE: Apply Anti-Seize to Each Mid-
Clamp prior to installation
FASTEN MIDCLAMPS: Return to each
inserted Midclamp. Ensuring Trim lip
is in contact with module face and
verifying alignment marks on T-bolts
are in proper position, tighten clamp.
TORQUE VALUE (See Note on PG. Q)
1/4” nuts to 10 ft-lbs w/ Anti Seize
MOUNT TRIM: Position Trim beneath
modules by sliding T-bolt into gap between
modules and tighten. Midclamp should stay
in position and support Trim. Tighten snugly
enough so that Trim is held firmly in place.
TORQUE VALUE: Do not exceed
specied torque value (10 ft-lbs)
ENDCLAMPS: Install Endclamps per
previous Endclamp install instructions
TORQUE VALUE (See Note on PG. Q)
1/4” nuts to 10 ft-lbs w/ Anti Seize
CLEAR T-BOLT SLOT: Rotate
unattached end of Trim out and away
from array so T-bolt slot (at next T-bolt
insertion point) is clear of modules.
This may require force to deect the
Trim slightly. Deect only enough to
insert T-bolt.
CUT EXCESS TRIM: Mark excess Trim
and cut at end of array or where
required for proper cantilevers.







TRIM RETROFIT INSTALLATION
W