How to Guide

Operation

Selecting Battery Type

Self-test starts, digital meter segments test

Software version test

Rated voltage Test

Rated Current Test

External battery temperature sensor test (if connected)

When the controller powers on, the Voyager will run a self-quality check mode and

automatically display the figures on LCD before going into auto work.

The Voyager provides 7 battery types for selection: Lithium-ion, LiFePO4, LTO, Gel,

AGM, Flooded, and Calcium Battery.

Pressing the AMP/VOLT Button will sequence through the following display parameters:

Battery Voltage, Charging Current, Charged Capacity (Amp-hour), and Battery Temperature

(if external temperature sensor connected)

Press and hold the BATTERY TYPE Button for 3 seconds to go into battery selection

mode. Press the BATTERY TYPE Button until the desired battery is displayed. After

a few seconds, the highlighted battery type will automatically be selected.

Incorrect battery type setting may damage your battery. Please check your

battery manufacturer’s specifications to when selecting battery type.

WARNING

NOTE

AMP/VOLT Button

Lithium ion batteries shown in the LCD indicate different types shown below:

Lithium Cobalt Oxide LiCoO2 (LCO) battery

Lithium Manganese Oxide LiMn2O4 (LMQ) battery

Lithium Nickel Manganese Cobalt Oxide LiNiMnCoO2 (NMC) battery

Lithium Nickel Cobalt Aluminum Oxide LiNiCoAlo2 (NCA) battery

LiFePO4 battery indicates Lithium-iron Phosphate or LFP Battery

LTO Battery indicates Lithium Titanate Oxidized, Li4Ti5O12 Battery