How to Guide

Installation

The Voyager has 4 terminals which are clearly labeled as “solar” or “battery”.

(Back)

Connect battery terminal wires to the charge controller FIRST then connect the solar panel(s) to

the charge controller. NEVER connect solar panel to charge controller before the battery.

Do not over-torque or over tighten the screw terminals. This could potentially break the piece

that holds the wire to the charge controller.

Refer to the technical specifications for max wire sizes on the controller and for the maximum

amperage going through wires.

The Voyager is designed for vertical mounting on a wall.

Never install the controller in a sealed enclosure with flooded batteries. Gas can

accumulate and there is a risk of explosion.

Choose Mounting Location—place the controller on a vertical surface protected from

direct sunlight, high temperatures, and water. Make sure there is good ventilation.

Check for Clearance—verify that there is sufficient room to run wires, as well as clearance

above and below the controller for ventilation. The clearance should be at least 6 inches (150mm).

CAUTION

WARNING

Mark Holes

Drill Holes

Secure the charge controller.

Mounting Recommendations:

Wiring