Owners manual

• Unscrew ring and place waterfall faucet
plate on faucet pressing down firmly.
• Screw ring back on tight.
• Screw top piece on and lever.
• Unscrew cover.
• Unscrew ring and place plate on.
• Hand-tighten gently avoid over-
tightening which may break plate.
Renovators Supply, Inc. © www.rensup.com
Waterfall Faucet Installation Instructions
Things You Will Need: Plumbers tape, wrench
1. Turn the handles on both the hot and cold water supply lines to the off
position so that the water will not be running through the pipes.
2. Wrap plumber’s tape around the two threaded ends of the supplied
water supply hoses to prevent leaking. Attach these hose into the
waterfall faucet body base. Tighten the hoses to secure them in place.
3. Lift the faucet & plate and position it over the hole in the countertop.
Place the up pad on top of the countertop in the faucet groove where it
goes. Slowly lower faucet & plate until they sit properly on countertop.
4. Place the down pad and clevis under the countertop securing them in
place with the screws and tightening the nuts.
5. Attach the flexible water supply lines to the hot and cold water supply.
Use a wrench to tighten the connections.
6. Turn the hot and cold water supply lines to the open position to allow
the water to run. Allow the water to run for a few minutes to remove any
possible air pockets in the pipes.
7. Place a clear bead of silicone caulk around the faucet plate base.
8. To place the glass disk on the faucet body, unscrew the two rings that
are located on the top of the faucet body. Place the glass disk on the
faucet and then hand-tighten the two metal rings back on.
These instructions and drawings disclose confidential and other data of proprietary nature owned
by Renovator’s Supply Inc. and may not be used or disclosed to others without the prior written
consent of Renovator’s Supply Inc. Renovators Supply, Inc.©