Instruction Manual

Instruction Manual Dual AutoGate Connect / 2022 Version 3 (GSD-100763)
Page 15
Connect Status
The messages that are sent to the server are:
Technician Set and/or Reset: When the Dual AutoGate passes through the technician set
and/or reset and displays the ON indicator.
Technician Set and/or Reset Fail: If any of the tests fail when the Dual AutoGate is set
and/or reset
Technician Visit: If the Dual AutoGate is visited and the button is pressed in any of the first
3 selections but the Technician test is not carried out.
Gate Closed: This is the initial state of the Dual AutoGate and indicates that this gate has
not been opened since it was last visited.
Gate Open: If a particular gate sees the programmed number of activations then the gate
will open and report this status
Gate Enabled: If another Dual AutoGate in the same zone has detected activity then the
server will send a command to the gate to enable instant open mode whereby it will open
if there is a single activation. This mode will expire within 5 days if there is no activity.
Gate Re-Closed: After the programmed open time (default 5 days) the gate will close and
report this status.
Gate Re-Opened: If another activation is detected then the gate will open immediately and
report this status. Note: other gates in the zone are not opened in this case.
iR Sensors Blocked: If there is an issue with the internal sensors then this error status will
be sent back.
Other data that is sent back from the AutoGates is: Battery Voltage, Signal Strength,
number of activations since reset and active count (i.e. not timed out).