Instruction Manual

Instruction Manual Dual AutoGate Connect / 2022 Version 3 (GSD-100763)
Page 9
Installing the Dual AutoGate and
Technician reset of the Dual AutoGate
Push the button to scroll through the menu in order to set the Dual AutoGate. The Dual
AutoGate is only successfully set when the indicator is displayed.
When the “Technician Setup” is selected then the door will move up/down/up to
test the motor and door sensors. If there is an error then E4 will be displayed on the
display.
After successfully testing the door the display will show 2 dots to indicate that it is ready
to set or reset the sensors as shown below.
Ready to set and/or
reset sensors.
Move hand in front of the Bait side sensor and the middle bars
will be displayed as shown.
Move hand in front of the right hand Entry side sensor and right
bar is displayed as shown.
Once all of the sensor beams have been set and/or reset, then the
display will be as shown.
NOTE - IN BRIGHT DIRECT SUNLIGHT, OCCASIONALLY THE
SENSORS WILL NOT PICK UP THE HAND MOVEMENT. TO
OVERCOME THIS ISSUE SIMPLY SHADE FROM DIRECT SUNLIGHT
Once all 3 sensors have been set and/or reset (in any order) the
radio will scan for connection to a Control Panel. If connected it
will display “r” and a number. The number is the signal strength
from 0-9. E.g. “r8” as shown. If there is no connection only the “r”
will be displayed while scanning.
Once the Gate is set and/or reset the ON symbol is lit as shown.