Owners manual

Do I have shunted or non-shunted tombstones?

If you choose to use your own tombstones simply make sure that yours are non-

shunted like in the photo below:

If you have shunted tombstones remove them from the socket on the end where the live

and neutral wires enter the fixture. Insert the non shunted tombstones and make sure

they snap securely into place.

Installation Instructions:

1) Remove or disconnect all of the wiring connected to the starter/ballast.

PAGE 1
Do I have shunted or non-shunted tombstones? If you choose to use your own tombstones simply make sure that yours are nonshunted like in the photo below: If you have shunted tombstones remove them from the socket on the end where the live and neutral wires enter the fixture. Insert the non shunted tombstones and make sure they snap securely into place. Installation Instructions: 1) Remove or disconnect all of the wiring connected to the starter/ballast.
PAGE 2
) When removing or cutting the wires from the G13 socket at the end of the fixture that does not have power or the "dead" end, make sure that they are tight in the fixture and will hold your new LED bulbs securely. 3) If you elect to leave the starter, ballast, or cut wiring in the fixture or if it cannot be easily removed, make sure that all unused lead wires are wire-nutted, rolled up, and secured out of the way.