User’s Guide REO-MECH Electric Rebar Cutters
WARNING: PLEASE READ THIS MANUAL CAREFULLY BEFORE USING THIS MACHINE Machine is not rated and should not be used for commercial rebar production purposes. 1. Safety This machine is a high performance, electric tool. Failure to follow safety instructions may result in serious injury. 1. Authorized personal protective equipment must be worn when operating machine (minimum requirement - safety glasses and protective gloves). 2. Take note of all warning signs on machine. 3.
Machine Specifications MODEL ERC-16 ERC-20 ERCP-20 ERC-25 ERC-32 Single Phase 220-240V AC ~50Hz or Single Phase 110-120V AC ~60Hz * Input Voltage Power Consumption 220-240V 900W 1000W 950W 1550W 2400W Power Consumption 110-120V 950W 1200W 1050W 1500W 2150W Net Weight 8kg 13kg 13kg 24kg 31kg Dimensions (cm) 46L x 27W x 12H 41L x 12W x 22H 50L x 13W x 14H 48L x 15W x 26H 52L x 17W x 27H Cutting Range 4-16mm** 4-20mm** 4-20mm** 4-25mm** 6-32mm** * Check machine label to det
3. Operating Machine Pre-use Checks: 1. Check oil level (refer to Maintenance section). 2. Check condition of cutter blocks and tightness of cutter block bolts (refer to Maintenance section). 3. Check power supply is properly earthed. 4. Check that power cord is undamaged and plug is not loose (also applies for extension leads). Warm Up: In cold weather, warm up unit for 60 seconds to ensure hydraulic oil reaches proper viscosity. Pull trigger and repeat cut cycle without material 15-20 times.
Cleaning: Clean machine after each use. Use protective gloves when cleaning to protect hands from metal splinters. Do not use air gun as this may cause dust and metal filings to enter vents. 1. Extend cutter rod and disconnect from power source. 2. Wipe or brush away all dust and metal filings. Pay particular attention to lower half of cutter rod. 3. Connect to power source to complete cut cycle. Oil Level Check: Check oil before each use.
RAPID TOOL AUSTRALIA Leading distributor of specialist construction tools & equipment www.rapidtool.com.
