User's Manual
Table Of Contents
- Trademarks
- Copyright Information
- Using This Manual
- 1 Introduction
- 2 Initial Use
- 3 Register & Update
- 4 Connections
- 5 Diagnosis
- 6 Service Function (Reset)
- 6.1 Oil Reset Service
- 6.2 Electronic Parking Brake Reset
- 6.3 Steering Angle Calibration
- 6.4 ABS Bleeding
- 6.5 Tire Pressure Monitor System Reset
- 6.6 Gear Learning
- 6.7 Anti-theft Matching
- 6.8 Injector Coding
- 6.9 Battery Maintenance System Reset
- 6.10 Diesel Particulate Filter (DPF) Regeneration
- 6.11 Electronic Throttle Position Matching
- 6.12 Gearbox Matching
- 6.13 AFS (Adaptive Front-lighting System) Reset
- 6.14 Sunroof Initialization
- 6.15 Suspension Calibration
- 6.16 IMMO Programming
- 6.17 EGR Adaption
- 6.18 Seats Calibration
- 6.19 Windows Calibration
- 6.20 Transport Mode
- 6.21 Gas Particulate Filter (GPF) Regeneration
- 8 Software Update
- 11 User Info
- 12 Synchronization
- 13 FAQ
- 14 Glossary of Terms & Abbreviations
- Warranty
asTech All-In-One User Manual
For non-OBDII vehicles, proceed as follows:
Note: If the power supply on vehicle diagnostic socket is insufficient or the power pin is damaged, you can
get power via either of the following ways:
A. Via Battery clamps cable: Connect one end of the battery clamps cable to the power jack of the OBD I
adaptor box, and the other end to the vehicle’s battery.
B. Via Cigarette lighter cable: Connect one end of the cigarette lighter cable to the power jack of the OBD I
adaptor box, and the other end to the cigarette lighter receptacle.
13