User's Manual

asTech All-In-One User Manual
It needs to be performed in the following cases:
1. The exhaust back pressure sensor is replaced.
2. The PM trap is removed or replaced.
3. The fuel additive nozzle is removed or replaced.
4. The catalytic oxidizer is removed or replaced.
5. The DPF regeneration MIL is on and maintenance is performed.
6. The DPF regeneration control module is replaced.
6.11 Electronic Throttle Position Matching
This function can utilize the diagnostic scanner to initialize the throttle actuator so that the learning
value of the ECU returns to the initial state. By doing so, the movement of the throttle (or idle motor)
can be more accurately controlled, thus adjusting the intake volume.
It needs to be performed in the following cases:
• After replacing the electronic control unit, the relevant characteristics of the throttle operation have
not been stored in the electronic control unit.
• After the electronic control unit is powered off, the memory of the electronic control unit’s memory is
lost.
• After replacing the throttle assembly, you need to match the throttle.
• After replacing or disassembling the intake port, the controlling of the idle speed by the coordination
between the electronic control unit and the throttle body is affected.
• The intake volume, and the idle control behavior has changed while staying at the same throttle
opening position, although the idle throttle potentiometer behavior hasn’t changed.
6.12 Gearbox Matching
This function can complete the self-learning of the gearbox and improve the shift quality.
It needs to be performed in the following cases:
 When the gearbox is disassembled or repaired.
6.13 AFS (Adaptive Front-lighting System) Reset
This function enables you to initialize the adaptive headlamp system.
6.14 Sunroof Initialization
This function can set the sunroof lock off, close in rain, memory function of sliding / tilting sunroof,
outside temperature threshold, etc.
6.15 Suspension Calibration
This function can adjust the vehicle body height sensor for level calibration.
It needs to be performed in the following cases:
1. When replacing the body height sensor, or control module in the air suspension system.
2. When the vehicle height is incorrect.
21