User manual

Chapter 2 USING THE HARD DRIVE ENCLOSURE

2.1 INSTALLING 2.5” HDD ENCLOSURE

Before using hard drive enclosure, please read these instructions for reference. Electrostatic

discharge can damage electronics components. Be sure you are properly grounded before being

any procedure. You can touch a mental part of computer’s chassis or power supply unit to discharge

any static charge that may have built up inside your body.

Handle SATA PCB board by the edge to avoid touching the electronic components. To avoid

damage to your hard drive, please handle carefully. Do not shake or drop the hard drive.

Please follow steps to disassemble the hard drive enclosure.

1. Press the two sides and pull out aluminum cover.

2. Connect 2.5” HDD into the connector on circuit board.