User's Manual

Heating/Cooling Setpoint Setting

Setting Heating or Cooling Setpoints

Setpoint Up and Down Buttons

Press either the Up or Down button in the main Thermostat Control Screen to go to the current system

operating mode (Heating or Cooling) Setpoint screen. as shown below.

Heating /Cooling Setpoint Adjustment Screen

The UP and DOWN buttons adjust the setpoint temperature. Pressing the UP button will increment the

setpoint value by one degree and conversely, pressing the Down button will decrement the setpoint one

degree. Pressing and holding a button will cause the setpoint to continuously change until the button is

released.

Setpoint Range: The setpoints can be set from 50°F to 90°F (4°C to 32°C) for heating or 55°F to 99°F

(10°C to 37°C) for cooling.

Setpoint Push: Note that you cannot lower the cooling setpoint below the heating setpoint. The

thermostat will “push” the heating setpoint lower if you try to lower the cooling setpoint below the heating

setpoint. It maintains a 3 degree separation between the heating and cooling setpoint. The same is true

for raising the heating setpoint above the cooling setpoint. Again the thermostat will “push” the cooling

setpoint up to maintain the 3 degree separation.

NOTE: If the system mode is OFF, pressing either the Up or Down buttons will take you to the

System Mode screen. You must first set an operating mode before you can change the setpoints.

To change the Heat Setpoint you must be in Heating mode, to change the Cool Setpoint you must

be in the Cooling mode. If you are in Auto mode, the mode of the last system call will be the

setpoint screen displayed.

Heating and Cooling

setpoint setting buttons.

Adjust setpoint to

desired temperature.

HEATING SETPOINT

DONE

Down

Press Done button to select new setpoint

and exit back to main thermostat screen.