Install Instructions

MAGNETIC HYDRAULIC SEPARATORS
33-00541EF—01 6
MAINTENANCE
To clean the hydraulic separator without switching off the
system, proceed as indicated below.
However, for more effective cleaning, it is advisable to carry
out these steps when the pumps are turned off, forcing the
flow to the dirt separator to be shut off. This process only
takes a few minutes. That way, all magnetic debris will stay
attached to the magnet upon removal.
NOTE: The magnet kit is composed of a magnet-holder
housing with gaskets for installation on hydraulic
separator and a magnet-holder cap for insertion in
the relative housing. To remove the magnet from the
housing, unscrew in a clockwise motion
.
1. During system function, the dirt is deposited on the
surface of the housing containing the magnet.
Fig. 8.
2. Remove the magnet from its container housing,
unscrewing in a clockwise motion. The dirt that has
been accumulated on the surface of the housing will be
deposited on the lower part of the hydraulic separator.
Fig. 9.
3. After waiting a few minutes, proceed with opening the
drain cock, turning counterclockwise.
Fig. 10.
4. Once the impurities have been removed, close the drain
cock again and reinsert the magnet in its housing,
screwing in a counterclockwise motion. The hydraulic
separator will resume normal function.
Fig. 11.