Specification

L4064A-F, J, R, T, W, Y FAN AND LIMIT CONTROLLERS
68-0024—02 6
1. To remove the slotted knockout(s), if any, use a needle-
nose pliers as shown in Fig. 6 and pull straight down.
Fig. 6. REMOVING SLOTTED KNOCKOUTS.
Fig. 7. INSERT STRAIN RELIEF BUSHING.
2. If cable is used, we recomend using a strain relief
bushing in the knockout (Fig. 7). Bushing is available
from your local electrical supply. The open side of the
bushing should face the open side of the knockout.
3. Refer to the following section for types of wiring con-
nections (standard wire push-in terminals or female
receptacle).
4. If strain relief bushing is used, close the movable gate
when all wires have been connected to the terminals
(Fig. 8).