User Manual

ResMed Confidential Proprietary Information, not to be reproduced or made available to third parties
without prior consent from ResMed and
not to be used in any unauthorised way.

ResMed Ltd 2016.
DOC NO 378015
PAGE 3 of 35
SPECIFICATION
– PRINTED MATERIALS
REV 5
At a glance Addition of ‘ClimateLineAir Oxy’ to the Air Tubing (heated and non-heated)
bullet, under the range of accessories available for use with the device.
Technical Specifications Supplemental Oxygen maximum flow values were modified as follows:
“For VAuto device: 4 L/min (CPAP, S, VAuto)
For S device: 4L/min (CPAP, S)
For ST device: 15 L/min (CPAP, S, ST, T)”
REVISION 3
Backwards compatible change / Changes trigger new document numbers for published multis
Section Heading Summary of change
Cover Included ST on front page.
Introduction Updated to include ST.
Indications for use 1. Included IFU part for MPMU/humidifier below the AirCurve 10 V Auto
and the AirCurve 10 S IFU:
The humidifier is intended for single patient use in the home
environment and re-use in a hospital/institutional environment. (Object
ID 18668; NP_IFU-humidifier).
2. Included IFU for ST:
AirCurve 10 ST
The AirCurve 10 ST device is indicated for the treatment of obstructive
sleep apnea (OSA) in patients weighing more than 66 lb (30 kg). It is
intended for home and hospital use.
The humidifier is intended for single patient use in the home
environment and re-use in a hospital/institutional environment.
At a glance section; explanation of
UI icons:
Updated to include the “Wireless transfer not enabled” icon.
Therapy Data – Wireless section Object 18881 has been updated to change first paragraph to the following:
Your <platform> device is equipped with cellular communication. This allows your
therapy data to be wirelessly transmitted to your care provider to enhance the
quality of your treatment. It also allows therapy settings to be updated in a more
timely manner or your device software to be upgraded. The Wireless signal strength
icon displayed at the top right of your screen indicates the signal strength.
Object 18882 has been updated to change “mains power” to “power outlet”
in second paragraph.
Therapy Data – SD card Object 16915 has been included before the section “To remove the SD
card” (Obj 15515):
Do not remove the SD card from the device when the SD light is flashing.
Troubleshooting Include Object 18942 after “Device may be in Airplane Mode” under “My
therapy data has not been sent to my care provider”:
Data transfer is not enabled for your
device.
Contact your care provider to enable the
data transfer service.
Warnings Include 2 new warnings:
Object ID 18952:
The device should not be used adjacent to or stacked with other equipment. If
adjacent or stacked use is necessary, the device should be observed to verify
normal operation in the configuration in which it will be used.