User's Manual
RE218 Honeywell
®
Compatible Trident
™
Environmental Sensor
Trident is an integrated environmental sensor. It detects water
and reports extreme temperature conditions.
Features
• Titanium probes for unmatched corrosion immunity
• IP67 rated waterproof enclosure
• GORE® vent equalizes enclosure pressure
• 5 year warranty
Enroll by placing the panel into wireless enrollment mode and
removing the battery tabs or tampering the sensor.
Loop Conguration
• Loop 1 = Heat
• Loop 2 = Flood
• Loop 3 = Freeze
• Loop 4 = Tamper
Install by placing the sensor in the location requiring water or air
temperature detection. If desired, the wall clip can be used to
secure the Trident sensor.
Optional Wall Clip Securing
• Remove the Trident body from wall clip.
• Secure wall clip to a surface with a #6 mounting
screw.
• Example securing locations: wall, baseboard or
Optional Wall Clip Securing
• Remove the Trident body from wall clip.
• Secure wall clip to a wall with a #6 screw.
• Example securing locations are a wall, baseboard
or cupboard.
Detects water pooled under the sensor and reports extreme air
temperature conditions.
Temperature Trip Points
• Heat larms when over 100.4° F (38° C)
• Heat restores when under 96.8° F (36° C)
• Freeze alarms when under 44.6° F (7° C)
• Freeze restores when over 48.2° F (9° C)
To replace the battery, insert a at blade screwdriver into the
front slot and twist. To reinstall the cover, align the rear latches
and roll the cover forward until it snaps into place.
I
N
S
T
A
L
L
G
U
I
D
E
I
Mounting Screw Hole
Front slot
Wall Clip
Verify proper enrollment and operation using your control panel’s installation manual.