User's Manual

ManualsBrandsResolution Products ManualsElectronicsHome Automation Device

RE920 IP Module

Features

• Connects in daughterboard slot of SimonXT panel

• Allows reporting of alarm and status conditions over IP connection

• Allows control of system functions (arming, disarming, etc) over IP

connection

• Allows control of Zwave devices and wireless siren over IP connection

Key Instructions

• Install RE920 unit in slot at back of panel

• Power up the panel

• Connect ethernet cable

• Connect to configuration software and enter MAC address

• Configure RE920 to correct IP address for reporting

• Configure RE920 to correct IP address for system control

LED Operation

• "L and S" LEDs are normal ethernet LEDs and indicate healthy ethernet

network connection

• "Power" LED lights green when powered and shows heartbeat for

processor functioning correctly

• "Local" LED lights when proper connection to local router established

• "CS" LED lights when connected to Central Station

• "Platform" LED lights when connected to interactive platform website

RE920_IP_Module_Manual.doc

Page 1 of 4 07-Apr-12

www.ResolutionProducts.com

Summary of content (4 pages)

PAGE 1
RE920 IP Module Features • Connects in daughterboard slot of SimonXT panel • Allows reporting of alarm and status conditions over IP connection • Allows control of system functions (arming, disarming, etc) over IP connection • Allows control of Zwave devices and wireless siren over IP connection Key Instructions • Install RE920 unit in slot at back of panel • Power up the panel • Connect ethernet cable • Connect to configuration software and enter MAC address • Configure RE920 to correct IP address for repo
PAGE 2
Specifications Panel Compatibility: External supply: Current draw: PCB dimensions: GE/Interlogix SimonXT 9-18V DC, at least 100mA. 60mA, normal operation. 1.9 x 4.1 inches Specifications subject to change without notice. Internal Picture Printed Zwave Antenna Factory Default Switch Ethernet LEDs Status LEDs Ethernet Connector Mounting Holes RE920_IP_Module_Manual.doc Page 2 of 4 www.ResolutionProducts.
PAGE 3
OEM Installation Instructions The RE920 module is installed in the SimonXT host as follows: 1. The SimonXT should be powered down. 2. Expose the back of the panel as shown in the following picture. 3. The module is installed in the expansion slot on the left, as shown in the picture. 4. Unwrap the module from its packaging and carefully slide the module underneath the plastic tabs at the top of the expansion slot. 5.
PAGE 4
Notices “GE” is a trademark owned by General Electric Company. "Interlogix" is a trademark of UTC. This Resolution product is not produced by, endorsed by, or officially associated with GE or UTC. Resolution recommends verifying operation at installation. This product is only usable with the GE/Interlogix SimonXT alarm panel. FCC Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: This device may not cause harmful interference.