Specifications

+
ENGLISH
E-14
BEFORE OPERATION
Remote Control Setup
Preparing the remote control
The battery is already set in the remote control, pull out the clear sheet from the battery cover
before using.
How to use the remote control
a) Point the transmitter of the remote control towards the receiver of the main unit. If an
obstruction to the signal exists, the remote control will not operate.
b) The distance from which the remote control can transmit is approximately 19 feet (6m).
Remote Control
1. Do not drop or place the remote control in water. (Damage may occur.)
2. Do not press the remote control buttons with sharp objects. (Damage may occur.)
3. The remote's signal may not be received properly if fluorescent lamps (Such as inverter
fluorescent lamps) are in the same room.
4. Operate with the remote control facing the main unit receiver.
5. The signal range is about 19 feet (6m).
6. Make sure there are no objects blocking the path of the signal.
7. Avoid dropping or damaging the remote control.
8. Do not use it in high humidity conditions or in direct sunlight or near a heat source.
Battery Information
1. Open the cover on the rear of the remote control towards the arrow.
2. Replace the battery with CR2025 battery. Be sure to set the battery with the (+) side up.
3. Close the cover to its original position.
4. The battery for this remote control is for initial use only. Change the battery when necessary.
5. When not using the unit or remote control for an extended period, remove the battery.
6. Store the battery where babies and children cannot reach them. If the battery is
swallowed contact a doctor immediately.
7. When discarding battery, cover the terminals of the battery with tape. If mixed with other metal or
batteries, heat, explosion or combustion may occur.
8. Bring the battery to a nearby electronics store, watch store or camera store to recycle them.
Front view
CR2025 Battery
Back view