Use Instructions
7
Notice: This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio, TV reception, or other
devices, which can be determined by turning the equipment on and off, the user
is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna (on the radio, TV, or other
device).
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer of the device for help.
Notice: Any changes or modications made to the device that are not expressly approved
by Respironics may void the user’s authority to operate the equipment.
For Canada only:
Notice: This ISM device complies with Canadian RSS-GEN.
Notice: This device complies with ISED license-exempt RSS(s).
Notice: This Wireless Modem contains IC: 8595A-2AGQN4NNN.
Notice: Operation is subject to the following two conditions;
(1) This device may not cause interference and
(2) This device must accept any interference, including interference that may cause
undesired operation for the device.
The Term “IC:” before the certication/registration number only signies that
registration was performed based on a Declaration of Conformity indicating that
ISED technical specications were met. The term “IC:” before the certication/
registration number does not imply that ISED approved the equipment.