User's Manual

- 22 -
To connect your breathing circuit to the device, complete the following steps.
Note: If you are using the optional 12 mm (non-heated) performance tubing, an adapter
is required to connect to the therapy device.
Note: Tubing is identied on the cu with the tubing identier symbol: “12”, “15”, “HT12”,
or “HT15”. 22 mm tubing contains no symbol.
1. Connect the exible tubing to the air outlet
on the therapy device.
To connect heated tubing (shown), line up
the connector on the heated tube with the
pin connection on the bottom of the air
outlet port on the device.
2. Press the heated tubing into place over the
air outlet port until the tabs on the side of
the tube click into place in the slots on the
sides of the outlet port.
If you are using standard tubing (not
shown), simply slide the tubing over the air
outlet port on the device.
3. If you are using the optional 12 mm heated tubing or 12 mm performance tubing,
connect the provided mask adapter to the mask connection end of the tubing.
4. Connect the tubing to the mask. For proper placement and positioning, refer to the
instructions that came with your mask.
5. Attach the headgear to the mask if necessary. Refer to the instructions that came with
your headgear.