User's Manual

- 6 -
Electrostatic
Discharge
(ESD)
Do not use antistatic or conductive hoses or conductive patient tubing with the device.
Pins of connectors marked with the ESD warning symbol shall not be touched and
connections shall not be made without special precautions. Precautionary procedures
include methods to prevent build-up of electrostatic charge (e.g., air conditioning,
humidication, conductive oor coverings, non-synthetic clothing), discharging one’s
body to the frame of the equipment or system or to earth. It is recommended that all
individuals that will handle this device understand these precautionary procedures at
a minimum as part of their training.
Condensation
Condensation may damage the device. If the device has been exposed to either
very hot or very cold temperatures, allow it to adjust to room temperature (operating
temperature) before starting therapy. Do not operate the device outside of the
environmental operating ranges listed in the “Technical specications” section later in
this manual.
Filters
A properly installed, undamaged Philips Respironics reusable pollen lter is required
for proper operation.
Dirty inlet lters may cause high operating temperatures that may aect device
performance. Regularly examine the inlet lters as needed for integrity and
cleanliness.
Never install a wet lter into the device. You must ensure sucient drying time for the
cleaned lter.
Make sure the air inlet (slotted) area on the side of the device is not blocked by
bedding, curtains, or other items. Air must ow freely around the device for the system
to work properly.
Extension
cords
Do not use extension cords with this device.
DC power
Always ensure that the DC power cord securely ts into your therapy device prior to
use. Contact your home care service provider to determine if you have the appropriate
DC cord for your specic therapy device.
When DC power is obtained from a vehicle battery, the device should not be used while the
vehicle’s engine is running. Damage to the device may occur.
Only use a Philips Respironics DC power cord and battery adapter cable. Use of any other
system may cause damage to the device.