User's Manual

- 17 -

2. Plug the socket end of the AC power cord

into the power supply

3. Plug the pronged end of the AC power cord

into an electrical outlet that is not controlled

by a wall switch

4. Verify that the plug on the bottom of the

device, at the power supply, and at the

electrical outlet are fully inserted. This

will help to ensure that a secure, reliable

electrical connection has been made.

Important: To remove AC power, disconnect the power supply cord from the

electrical outlet.

Setting up the integrated humidier

Warning: Allow the heater plate and water to cool down for approximately 15

minutes before removing the water tank. A burn may result from: touching

the heater plate, coming in contact with the heated water, or touching the

tank pan.

Cautions

• Do not attempt to ll the humidier water tank while it is still attached to the device.

• Use only room temperature distilled water in the tank. Do not put any chemicals or

additives into the water. Possible airway irritation or damage to the water tank may

result.

• Do not ll the humidier water tank above the maximum ll line. If the humidier water

tank is overlled, water may leak into the therapy device, humidier, or onto your

furniture. Damage to the therapy device may occur.

Note: Clean the humidier water tank before rst use. Refer to the “Home cleaning:

humidier water tank” section in this manual.