User manual

Us e r Ma n U a l14
3.4 sU p p l y I n g aC po W e r T o T h e de v I C e
CAUTION: If this device has been exposed to either very hot or very cold temperatures, allow
it to adjust to room temperature (operating temperature) before beginning the
followingsetupprocedures.Donotoperatethedeviceoutsideoftheoperating
temperaturerangeshowninChapter8.
WARNING: Route the wires to avoid tripping.
WARNING: is device is activated when the power cord is connected. Pressing the button
turns the airflow and humidifier (if activated) on or off.
CompletethefollowingstepstooperatethedeviceusingACpower.
1. PlugtheprongedendoftheACpowercordintoanelectricaloutletthatisnotcontrolledby
a wall switch.
2. Plug the power cord’s connector into the power inlet on the back of the device, as shown in
Figure3–5.
Filter Area
AC Inlet (back of unit)
Power Cord
fI g U r e 3–5 Co n n e C T I n g T h e po W e r Co r d T o T h e de v I C e
3. Ensure that all connections are secure.
IMPORTANT:ToremoveACpower,disconnectthepowercordfromtheelectricaloutlet.
WARNING: Inspect the power cord often for any signs of damage. Replace a damaged power
cord immediately.
WARNING: Donotuseextensioncordswiththisdevice.
3.5 se T U p T h e In T e g r a T e d hU M I d I f I e r
WARNING: DonotusetheSleepEasydevicewithoutthewaterchamberinplace.
fI r s T Us e
1. Slidethewaterchamberoutfromthesideoftheunit.