User manual

15Us e r Ma n U a l
2. Gentlyremovethebaseofthechamberwithyourhands,beingcarefulnottodamagethe
rubber seal.
3. Removetheappervalvefromtheairinletport;uncliptheprotectivecoverfromthetopof
thewaterchamber,asshowninFigure3-6.Washthesepartsby hand only in a solution of
warm water and mild liquid dishwashing soap. Rinse the parts with clean water and allow
them to air dry.
Flapper
Valve
Protective
Cover
Soft Flap
fI g U r e 3–6 fl a p p e r va l v e a n d pr o T e C T I v e Co v e r
4. Wash the water chamber and heater plate in the dishwasher (top shelf only) or by hand in a
solution of warm water and mild dishwashing soap.
5. Reassemble.Inserttheappervalveintotheairinletport,andcliptheprotectivecoveron
topofthewaterchamber,asshowninFigure3-6.
6. Fill the chamber to the fill line with distilled water.
CAUTION: Use only distilled water in the chamber.
7. Slidethechamberintoplaceonthesideoftheunit.ContinueasinstructedinStep5of
DailyUse.
da I l y Us e
1. Slidethewaterchamberoutfromthesideoftheunit.
2. Beforeeachuse,checktheappervalveoperation.Visuallyinspectthesoftaptomakesure
itisfreetoopenandclosewheninstalledinthewaterchamber.Checktomakesurethesoft
flap is not pushed back into the flapper valve. Replace the valve if the soft flap is damaged or
missing.Makesuretheprotectivecoverisclippedintoplaceontopofthewaterchamber.
3. Beforeeachuse,rinsethechamberwithwater.Fillthechambertothelllinewithdistilled
waterusingthefunnel,asshowninFigure3-7.
Fill Line
fI g U r e 3–7 fI l l I n g T h e Wa T e r Ch a M b e r