User manual

Us e r Ma n U a l18
5. Makesurethatnoairisleakingfromyourmaskintoyoureyes.Ifitis,adjustthemaskand
headgear until the air leak stops. See the instructions provided with your mask for more
information.
NOTE: Asmallamountofmaskleakisnormalandacceptable.Correctlargemaskleaksoreye
irritation from an air leak as soon as possible.
6. If you are using the device in bed, try placing the tubing from the device over your
headboard. is may reduce tension on the mask.
NOTE: If you are having trouble with your mask, refer to the instructions supplied with the mask.
NOTE: You must remove the mask and patient circuit before you get out of bed.
4.2 Us I n g T h e ra M p fe a T U r e
YoucanpresstheRAMP button to activate the Ramp feature, if your provider has enabled
this feature.
4.2.1 ra M p fe a T U r e
e device is equipped with an optional ramp feature that your home care provider can enable or
disable. is feature reduces the air pressure when you are trying to fall asleep and then gradually
increases (ramps) the pressure until your prescription setting is reached, allowing you to fall asleep
more comfortably.
Iframpisenabledonyourdevice,afteryouturnontheairow,presstheRAMPbuttononthe
topofthedevice.YoucanusetheRAMPbuttonasoftenasyouwishduringthenight.
NOTE: Iftherampfeatureisdisabled,nothingwillhappenwhenyoupresstheRAMPbutton.
4.2.2 se T T I n g ra M p
isscreenisenteredbypressingandholdingtheRAMP button for 3 seconds. e Ramp
StartingPressureScreenwillappear,Figure4-4.Itcanbeenteredfromeitherthestandbyor
operate screen.
fI g U r e 4-4 ra M p sT a r T I n g pr e s s U r e sC r e e n
Youcanincreaseordecreasetherampstartingpressurein0.5cmH
2
O increments by pressing the + or
–buttons.edefaultsettingis4cmH
2
O.Youcanadjustthesettingfrom4cmH
2
OtotheCPAP
pressure setting.
NOTE: is screen will not display if your provider has not enabled Ramp on your device.
After you have finished modifying this screen, press the button to return to the Standby
screen.