Installation guide

Advisor Master Programming Guide 95
No: Use pulse dialling.
Enable PSTN line fault monitor
NO-Enable Line Monitor
*-Change 0-Skip
A line monitor will detect if the line voltage on the telephone network is within
limits. If not, a telephone line failure will occur.
Yes: Enable the line monitor.
No: Line monitor is disabled.
Press 0 to skip further options and move to central stations.
Monitor service tones
NO-Monitor Service Tones
*-Change 0-Skip
Reserved for future use
Use 3 digit SIA extensions
YES-3 Digit SIA Extensions
*-Change 0-Skip
Select if SIA reporting uses 2 or 3 digit zone, point or user numbers. When 2
digits are used, numbers above 99 will be converted to 99.
Yes: SIA reporting uses 3 digit numbers.
No: SIA reporting uses 2 digit numbers.
Press 0 to skip further options and move to central stations.
ISDN point to point
NO-ISDN Point to Point
*-Change 0-Skip
This option allows you to select the point to point mode of operation for the plug-
in ISDN dialler.
Enable ISDN line fault monitor
NO-Enable ISDN Line Fault Monitor
*-Change 0-Skip
If set to Yes, the line monitor will detect if the line condition on the telephone
network is within limits. If it is not, a telephone line fault condition will be
activated.