Installation guide

Advisor Master Programming Guide 97
Note: Setting is ignored if “Enable buzzer on mains/line fault” on page 84 is set
to Yes.
GSM line fault
YES-Enable GSM Line Fault Monitoring
*-Change 0-Skip:
Enables GSM Line Fault Monitoring.
Note: The panel requires a reset in order for the change to take effect.
Select the central station
Central Station 1..4
CS No:
Enter the central station to program.
Select the reporting format
Disabled
Format No:
Every central station can report using a different format. There are following
reporting formats available:
• 1: Tecom Dialler V1 (only used in Australia)
• 2: DTMF Contact ID — Small
• 3: DTMF Contact ID — Large
• 4: SIA — Small
• 5: SIA — Large
• 6: X-SIA — Small
• 7: X-SIA — Large
• 8: 200 Baud FSK — 1
• 9: 200 Baud FSK — 2
• 10: 200 Baud FSK — 3
• 11: 200 Baud FSK — 4
• 12: X25 ENAI
• 13: Voice Reporting — Acknowledge
• 14: Voice Reporting — No Acknowledge
• 15: Secure Stream
• 16: Reserved
• 17: Reserved
• 18: Securitel Serial
• 19: Securitel PIN
Note: X-SIA — Small and X-SIA — Large are protocol options. The difference
between “Small” and “Large” is the amount of system events it will report. The
large formats will report most system events.
See also “42-Reporting class database” (page 161) and “Reporting” (page 180)