Installation guide

100 Advisor Master Programming Guide
X25 line type
X25 Line type - 0
Value:
Sets the polling time of the line.
• 0: Permanent 15 minutes polling.
• 1: Permanent 90 seconds polling.
Connection type
• 0-PSTN: CS reports via the on board PSTN dialler
• 1-ISDN: CS reports via the plug-on ATS7100/712x ISDN dialler
• 2-ISDN-D: CS reports via the plug on ATS7110/712x ISDN dialler
• 3-GSM: CS reports via the plug on ATS7300/7310 GSM dialler
• 4-Universal Interface: CS reports via the ATS1801 and the plug on
ATS1806/1809 IP interface (to OH Digital Receiver)
Suppress FTC for voice
NO-Suppress FTC for voice reporting
*-Change 0-Skip
Suppresses Report Fail (FTC) messages and Fault LED on the RAS for when
the panel fails to complete voice message delivery only. The “'Voice I/F fail”
message, caused by hardware failure when the panel is unable to communicate
with the ATS7200/7200N board, is not suppressed by this option. The FTC will
still be LOG.
Retry counter
Retry Count: 14
Count:
Enter the maximum number of retries allowed on each Central Station. The
default is 14 retries. The exception is Italy where the default is 2 retries (on
Central Stations set on Voice Reporting).
SIA area modifier
NO-SIA Area modifier
*-Change 0-Skip
Allows the user to send multiple areas open/close events using the same
account code (as in CID).
It allows identifying more than one area using only one account code. System
events are reported using the configured system account number (current
behaviour) and an area code 0 (see example below). All area events use area 1
account number.
Examples are:
• Nri02/BA12: New event, Area 2, BA on zone 12.