Installation guide

Advisor Master Programming Guide 101
• Nri11/ZR123: New event, Area 11, ZR on input 123.
• Nri00/RR316: New event, power-up
X25 D-Bit
YES-X25 D-Bit
*-Change 0-Skip
Specifies the X25 D-Bit option ON or OFF for an ISDN-D network configuration.
Yes: D-Bit option for an ISDN-D network is ON.
No: D-Bit option for an ISDN-D network is OFF.
Notes
• Default setting for The Netherlands is ON.
• Default setting for Belgium if OFF.
Mains fail reporting delay [min]
Mains Fail Reporting Delay (Min) - 0
Time:
The panel detects a Mains Fail event when the AC mains supply is absent for
longer than the programmed “Mains fail delay time” on page 66 (in “6-Timers”).
The mains failure event is reported to a programmed central station if “Report
mains fault” on page 96 is set to Yes (“9-Communication options”).
In order to prevent frequent reporting of mains failure events when Mains fail
delay time is programmed to 0, a timer is employed to delay reporting. If the
mains event restores prior to expiration of the timer, the event shall not be
reported to the central station.
Enable IP line fault monitor
NO-Enable IP Line Fault Monitor
*-Change 0-Skip
Yes: Universal interface ATS1806/1809 will supervise an Ethernet data link.
No: Ethernet connectivity problems detected by the ATS1806/1809 will be
ignored.
AWDGP reporting codes for IMQ
NO-AWDGP reporting codes for IMQ
*-Change 0-Skip
When this option is set to Yes, the alternative SIA reporting code will be
transmitted to the Central Station.