Installation guide

102 Advisor Master Programming Guide
10-Program text
The ATS control panel uses a library of pre-programmed words that are used
when programming the names or texts into the system (e.g.: zone names, area
names, etc.) These words form part of the variable text that appears on the LCD
display.
All the words in the library are identified by a reference number, which ranges
from 001 to 899. See Table 9 on page 104 for the list of pre-programmed words
available.
Not all words can be in the library. Therefore an additional 100 words can be
programmed freely. The menu 10-Program text is used to add these new words
to the ATS library. Words are considered any combination of 16 characters. They
can include numbers, spaces (making two words for one reference number), or
punctuation.
Note: For version V04.08.17 and later, as well as for V04.11.01 and later, the
range is 001 to 799. These versions support 200 programmable text words,
starting at 800. In the following sections, whenever 0900 is shown, this can be
0800 for these firmware versions.
Program text words
0900: ARITECH , (*) - Next
Text No:
When programming text, first select the reference number to use (800 or 900 to
999). If words are already programmed, press Menu to go through the list. Select
the number to program.
0900: ARITECH , (*) - End
ARITECH
When the number is selected, the word already programmed is shown and can
be changed. Press Enter to move to the next character.
To change a character, select it by pressing the correct number button (see
Figure 1 on page 103). To accept the character, press Enter. The maximum
length of text is 16 characters.
0900: ARITECH , (*) - End
ARITECH SALES_
Once the text is correct, press Menu to accept the text. It will be shown to
confirm. Press Menu again to accept the text.
To delete a character, select a whitespace character (under [9], see Figure 1 on
page 103).