Installation guide

Advisor Master Programming Guide 121
16-Event to output
Programming section to link events to outputs. Outputs are available as relay
cards (ATS1810, ATS1811) or open collector outputs (ATS1820/1821).
Before an event flag actually will activate an output, a number of conditions have
to be met:
• The timezone has to be valid (if programmed).
• The output logic defines how the output behaves when the timezone is valid.
• The output behaviour can be set to normal or inverted.
Only for a correct combination of conditions, the output will activate. See figure 2
for an overview.
Figure 2: Basic functionality for outputs
 Invalid
Event flag


Output
normal /
inverted

 Valid

Output logic


Physical output
Timezone
Output number
Event To Ouput
Output No:
This is the physical number of the output. Each output has a specific number that
will identify the output to the control panel. The output number is determined by
the address of the device the relay card is connected to.
See Advisor Master Installation Guide for more information on output numbers on
devices.
Configuring event to output
Event flag number
Output 3 Mapped To Event Flag 123
Event Flag:
An event flag or a timezone activates an output. Enter the event flag number
here.
The output follows the event flags during a valid timezone. If event number 0 is
programmed, the output does not follow any event flag.